To Next PageTo Next Page
Need help?Do you have a question about the Objet Connex500 and is the answer not in the manual?
Procedure for cleaning print head orifice plates to prevent clogged nozzles and ensure print quality.
Perform a pattern test to verify print head nozzle condition and overall print quality.
Steps to resolve poor print quality issues identified through pattern testing.
Guide to checking and adjusting the alignment of print heads for accurate model printing.
Procedure to calibrate print heads for optimal performance and consistent output.
Instructions for identifying and replacing defective print heads using the automated wizard.
Test and calibrate UV lamp radiation levels to ensure proper model curing.
Utilize built-in tests for hardware/software checks, diagnostics, and troubleshooting.
Procedure for replacing the printer's waste container to maintain operational safety and efficiency.
Guidelines for safely cooling and removing printed models from the build tray.
Methods for effectively removing support material from finished 3D printed models.
Best practices for storing printed models to prevent deformation and maintain integrity.
General| Technology | PolyJet |
|---|---|
| Layer Thickness | 16 microns |
| Number of Materials | Up to 14 materials simultaneously |
| XY Resolution | 600 dpi |
| Build Volume | 490 × 390 × 200 mm |
| Build Size | 490 × 390 × 200 mm |
| Material Capabilities | Rigid, flexible, transparent, high-temperature |
| Accuracy | Up to 0.1 mm |
| Print Speed | Up to 20 mm / hour / strip |
| Connectivity | Ethernet, USB |
| Power Requirements | 230V, 50/60Hz |
