Objet Connex500 - Connex Printer Startup Guide

Operating & Maintaining the Connex500/350 3-D Printer
7–2 DOC-13000 Rev. E
Figure 7-1: The Connex500 3-D Printer
Starting the Connex Printer
1. Turnonthemainpowerswitch,locatedatthebackoftheConnex
printer.
Figure 7-2: Main power cable and switch
ThemainpowerswitchturnsontheConnexprinter,whichincludes
thebuilt‐inConnexcomputer.
Printer cover
Printing-materials &
storage compartment
CAUTION!
• Do not attempt to operate the Connex printer before being trained by
an Objet customer-support representative.
• Observe all safety warnings and follow the safety guidelines described
in chapter 2.
All manuals and user guides at all-guides.com