Introduction
OCEASOFT LoRaWAN Receiver User Guide Page 3
Certifications and compliance
Caution: Any changes or modifications made to this product not expressly
approved in writing by OCEASOFT could void the user's authority to operate the
equipment.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1)
This device may not cause harmful
interference.
(2)
This device must accept any interference
received, including interference that may
cause undesired operation: FCC Part 15 §107 -
§109 - §207 - §247 (Ed 2008).
FCC RF Radiation Exposure
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for
satisfying RF exposure compliance. This transmitter must
not be co-located or operating in conjunction with any
other antenna or transmitter.
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is sub
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device. Under Industry Canada
regulations, this radio transmitter may only operate using
an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent is
otropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
To Next Page
Loading...