Service Manual RU OHAUS
Page 22 / 53 11/01/2010 Ohaus
10. Warning Messages
INPUT TOO BIG The input is too big.
INPUT TOO SMALL The input is too small.
TOO MUCH INPUT The input is out of limit.
WRONG CODENR. The code number is invalid.
KEY NO FUNCTION The key has no function.
KEY BLOCKED The key is disabled. Check the KEYBOARD CONFIGURE.
PLU NOT FOUND The entered PLU number does not exist.
AG NOT FOUND The entered Group number does not exist.
OPER.NOT FOUND The entered Operator number does not exist.
LABEL NOT FOUND The entered Label Format does not exist.
PLUNR IS OCCUP
You are trying to duplicate a PLU into an existing PLU
number.
LABELNR. OCCUP
You are trying to duplicate a label format into an exist label
format number.
AG NOT DELETABLE This Group contains total data and can not be deleted.
OP NOT DELETABLE This Operator contains total data and can not be deleted.
MEMORY FULL Memory is full.
WEIGH AGAIN
You are trying to record one item twice. Remove the item
from the platter and put a new item on the platter.
WRONG LABEL
The installed label roll does not match the configured label
format.
LABEL MOVED
The stepper motor or the rewind motor is not working
properly.
CHANGE PAPERROLL The label roll is not installed or the label roll is empty.
TAKE LABEL OFF Take off the current label before printing the next one.
NO FREE OX KEY All the configured operator keys have been occupied.
PRINT TICKET Print out the customer ticket before logging out.
OPEN CUST. TICK You are trying to delete an operator who has total data.
OX NOT LOGGED-IN The operator has not be assigned to an operator.
PAYMENT TOO LOW The payment is less than the total amount.
NO FURTHER REG. No further transaction has been recorded.
DISCOUNT IMPOSS
This PLU does not allow to be discounted. Check the PLU
Discount configuration, or this PLU is in special offer.
TARE TOO BIG The entered tare is too big.
PLU TARE ACTIVE You are forbidden to override the PLU tare.
NO STABLE WEIGHT The weight is not stable.
PUT PLATTER ON The weight is too small and out of power up zero range.
ZERO NOT CAPTURE The weight is too big and out of power up zero range.
WEIGHT TOO SMALL The weight is too small to be printed.
ERROR TAKE-SENS The take label sensor is not working properly.
ERROR POS_SENS The gap sensor is not working properly.
ERROR INTERFACE The serial port is not working properly.
To Next Page
Loading...
