Service Manual RU OHAUS
Page 27 / 53 11/01/2010 Ohaus
13. Replace switch power
Take out switch power
• Power off and take out the power cable from electrical outlet.
• Take away platter.
• Screw out the 5 bolts (A) from base and take away.
• Pull out the harness in switch power.
• Screw out 4 bolts in the power PCB.
• Take away the switch power.
Install switch power
• Put the switch power to the right position.
• Screw in 4 bolts of the power PCB.
• Plug in all the connection harness in the PCB.
• Put the cover of base then screw in 5 bolts.
• Put on platter.
• Power on scale.
To Next Page
Loading...
