Service Manual RU OHAUS
Page 23 / 53 11/01/2010 Ohaus
10.1 Error Messages
Listed below are the possible error codes are listed. When an error code appears, the
scale should be switched off and on. In many cases the error will disappear.
There are 3 different kinds of error messages:
Error Status 1:
Warning! After the warning the scale can still be used.
Error Status 2:
Press "CODE" key. Change to one of the CODE menu. Back to normal operation
mode.
Error Status 3:
Press "CODE" key and enter SERVICE MODE, after returning to normal operation
mode the scale will perform RESET.
To Next Page
Loading...
