OHAUS Scout pro - Setup Menu Configuration

EN-12 SCOUT PRO
1
PRINT
Unit
Entering the .S.E.T.U.P. Menu
The .S.E.T.U.P. menu contains Auto-Off, Linearity Calibration, Mode (Display Hold,
Totalize, Specific Gravity) and END. Auto-Off can be turned on or off. Display Hold,
and Totalize require entering the Mode submenu.
Starting from the .C.A.L. menu.
1
(First menu)
Select ON or OFF for Auto-Off. To enter
Display Hold, Totalize or Specific Gravity,
you must first enter the Mode sub-menu.
ON/ZERO
Off
1
ON/ZERO
Off
1
PRINT
Unit
1
ON/ZERO
Off
(To exit and save)
Turning Display Hold, Totalize or Specific Gravity Mode On
NOTE: Only one mode can be active at one time.
Start at the .S.E.T.U.P. menu.
PRINT
Unit
(Press repeatedly to)
ON/ZERO
Off
PRINT
Unit
1
PRINT
Unit
1
Press YES to desired mode, then continue.
Y
Y
Y
Y
N
N
N
N
N
PRINT
Unit
1
N