Ohmeda Biox 3700 - Page 102

COMPUTER INTERFACE TREND-OUTPUT MODE
Ohmeda Biox 3700 Oximeter Communication with Computers
TREND-OUTPUT MODE
Enabling Depress the oximeter Sa02 TREND 20/60 key a second time
to start the Trend-Output. The data is output to the
computer screen in the following format:
**POWER ON**
:SA02=XXX PR»XXX
:SA02»XXX PR=XXX
This Status Message Appears on the Oximeter Graphic
Display:
OUTPUTTING TREND
TIME REMAINING: XiXX
HIT TREND KEY
TO END OUTPUT
The Oximeter Status message is updated approximately
every second to inform the operator of the hours and
minutes of Trend Data remaining. If the previous Trend ^^
Data is being output, messages which appear on the •
Oximeter Graphic Display do NOT appear on the computer
terminal. Instead, the Sa02 and Pulse Rate equal zero
when this situation occurs.
NOTE: Eight hours of Trend Data is output in approximately eight minutes.
Exiting To exit the Trend Output Mode while data is being
output, press the Oximeter Sa02 TREND 20/60 key.
After the Trend Data is output the oximeter returns to
the previous display and the Auto-Output Mode
automatically resumes. The Trend Data is still in
memory and can be output again without turning the
oximeter on and off again.
/*m%
1118-301 05/09/86 81b