Ohmeda Biox 3700 - Page 64

1118-301
STATUS MESSAGES
MESSAGE
DESCRIPTION
displays remain on the display, but do not change. When the
interference has stopped, valid readings (aged 12 seconds while
in the Fast Response Mode or aged 24 seconds while in the Slow
Response Mode) return to the display in approximately 2 seconds,
and the oximeter begins collection of Trend Data again. The
data is current within 6 seconds in the Slow Response Mode or 3
seconds in the Fast Response Mode.
'LO BT'
'OHMEDA-BIOX 3700
REVISION: X
SYSTEM CHECK
IN PROCESS"
"OUTPUTTING TREND
TIME REMAINING X:XX
HIT TREND KEY
TO END OUTPUT"
"PLEASE PLUG UNIT
INTO WALL OUTLET
TO DETERMINE
LINE FREQUENCY"
"THANK YOU
UNIT MAY NOW RUN
ON BATTERY"
Displayed alongside the plethysmographic
waveform when approximately 5 to 10 min
utes of battery operation is left.
Displayed momentarily when the unit is
turned on.
NOTE: X represents an alphanumeric value
Displayed while the oximeter is output-
ting the Trend Data via the Sa02 and
Pulse Rate Analog or Digital Output.
NOTE: "X:XX" represents the hours and
minutes left in the trend data output.
It also represents the time before trend
data output is complete in minutes and
seconds.
Displayed at power-up when the oximeter
has lost the battery-backed RAM.
Displayed after the unit is plugged in.
- 57 -
01/27/86
s*%