Oki 182 - Page 15

___________ CHAPTER 1 SETTING UP
6. Press gently on the cartridge until you feel it snap into place. To
remove
the ribbon cartridge, make sure the print head is away
from
the rollers, then grasp the cartridge on both sides of the
print head and lift up.
7. The blue lever located to the left of the ribbon cartridge is used
to adjust the print head gap for single- or multi-part paper.
-
When single-part paper
or two-part paper is in the printer, slide
the blue lever toward the
print head. To print on three- or four-
part paper, slide the lever away from the print head.
-
-
7