B6250/B6500 User’s Guide> 165
UPC, EAN, Code 128:Four parameters are required. The parameters
indicate how wide to render drawn bars in 1/600th inch units for
stacks of 1, 2, 3, and 4 modules, respectively.
Code 39,
I-25 Two parameters are required. The parameters indicate the
width of the narrow and wide bars, respectively.
F
UNCTION
2
PARAMETER
INTERPRETATION
In Function 2, the first parameter specifies the desired unit module
width in 0.001 inch units (mils). The second parameter indicates the
desired wide-to-narrow ratio. The value to enter here is an integer
representing the desired ratio multiplied by 100.
For example, to specify a unit module width of 17 mils and a wide-
to-narrow ratio of 2.5, you would use the following sequence:
Esc(s17;250B
The second parameter is optional. If omitted, a traditional default
wide-to-narrow ratio will be used (actual value depends on the
barcode type).
S
PACE
W
IDTH
C
ONFIGURATION
“S” parameter Esc(s#1,#2,#3,#4s
This parameter must be set when using “Function 1” of the Bar
Width Configuration (or “B” parameter (see description above)
The parameters are interpreted exactly as in Function 1 of the “B”
parameter, except that this parameter specifies the width of the
spaces in the barcode, as rather than the width of the bars.
Note: There is no "function 2" variety of this command.
“S” parameter example:
The syntax for the “S” parameter is always in “function 1” form (see
“function 1” of “B parameter decription). The “S” parameter would
only be used when using “function 1” of the “b” parameter.
Therefore, the example would really look like this:
(When included in the same escape command:)
<ESC>(s8,16,24,32b8,16,24,32S
(and when done separately)
To Next Page
Loading...
Need help?
General
