B6250/B6500 User’s Guide> 27
You have to configure the settings on the control panel too when
loading custom size paper in trays 1 to 4 for printing. For details on
setting the control panel, refer to “ Setting Custom Paper Sizes”
(P. 52).
Important:
• When setting the paper size on the print driver and the
control panel, be sure to specify the same size as the actual
paper used. Setting the wrong size for printing will cause
machine failure. This is especially true if you configure a
bigger size when using a narrow width paper.
On the print driver, set the custom size in the [Paper Size] dialogue
box. This section explains the procedure using Windows XP as an
example.
NOTE
> For Windows NT 4.0/Windows 2000/Windows XP, only
users with administrator’s rights can change the settings.
Users without the rights can only check the contents.
1. From the [File] menu, click [Print].
2. Select [Properties] then select the [Setup] tab.
3. Select Option as needed: Source, Media Type, etc.
4. You may select a previously stored custom size from the list
or you may add an additional custom size.
5. To add a new custom size:
A. Select paper feed options.
B. Select Custom Size.
C. In the Name Field, Type a name for your custom size.
D. Click on the unit of measure radio button for the units
you would like to use (mm for millimeters or inch for
inches.)
E. In the width field, enter the width of the custom size
paper (89 to 216 mm, 3 to 8.5 in.).
F. In the length field, enter the length of the custom size
paper (146 to 356 mm, 5.75 to 14 in.).
G. Click add to store the new custom size.
To Next Page
Loading...
Need help?
General
