Operator panel > 31
STSTEM
ADJUST
(cont.)
TIMEOUT INJOB OFF
5 SEC
10 SEC
20 SEC
30 SEC
40 SEC
50 SEC
60 SEC
90 SEC
120
SEC
150 SEC
180 SEC
210 SEC
240 SEC
270 SEC
300 SEC
Specifies how many seconds the printer will
w
ait when received data pauses before forcing
a page eject.
In PostScript Emulation mode the jo
b will be
cance
lled if timeout occurs.
TIMEOUT LOCAL 0 SEC
5 SEC
~
40 SEC
~
290 SEC
295 SEC
300 SEC
Sets how long each port is left opened after a
jo
b is comp
lete. (The network is excluded.)
TIMEOUT NET 0 SEC
5 SEC
~
90 SEC
~
290 SEC
295 SEC
300 SEC
Sets how long the network port is left
opened
after a job is
complete.
LOW TONER CONTINUE
STOP
Specifies whether the printer should continue
printing e
ven after a low toner condition is
detected.
EMPTY COLOR TONER ALARM
CANCEL
Specifies the action when there is an empty
col
or toner
.
JAM RECOVERY ON
OFF
Specifies whether the pri
nter should perform
jam recove
ry after a paper jam has occurred.
If ON, the printer will attempt to re-print any
pages lost due to a paper jam once the jam
has been
cleared.
ERROR REPORT ON
OFF
If ON,
the printer will print error details when
a PostScript Emulatio
n error occurs.
Note: Applies tp PS & PCL XL only.
HEX DUMP EXECUTE Prints out data received from the host PC in
h
exade
cimal Dump.
Turning off the power supply switch restores
Normal Mode from HEX Dump Mode.
ITEM SETTINGS EXPLANATION
To Next Page
Loading...
