- 24 -
2. Setting Up
When the additional tray unit is installed, be sure to set the number of trays after the printer
driver is installed.
For the information of installing the printer driver, see "Installing the Wireless LAN module".
• To follow this procedure, you must log in to a computer as the administrator.
• If your Mac OS applies to the following conditions, the information about the installed option is automatically obtained,
not requiring you to set the printer driver.
- When the machine is connected to a network over Bonjour
- When the machine is connected via USB interface
- When the optional equipment is installed before the printer driver is installed
• Setting Additional Tray(s) to the Windows PCL Printer Driver
1
Click [Start], and then select [Devices and Printers].
2
Right-click [OKI C532], and then select [OKI C532 PCL6] from [Printer
properties].
3
Select the [Device Options] tab.
4
Enter the total number of trays and then click [OK].
• If a TCP/IP network connection is used, click [Get Printer Settings] to set the number of trays automatically.
• For the Windows XPS printer driver, follow the steps for the Windows PCL printer driver to make a setting.
• Setting Additional Tray(s) to the Windows PS Printer Driver
1
Click [Start], and then select [Devices and Printers].
2
Right-click [OKI C532], and then select [OKI C532 PS] from [Printer
properties].
3
Select the [Device Settings] tab.
Setting the Printer Driver
To Next Page
Loading...
Need help?
General
