- 64 -
3. Basic Operations
6
Insert the paper with the print side up until its edge touches the paper feed
entrance.
Do not load paper above the " " mark.
When a printer is in the power saving mode, press the (Power Save) button to restore from the mode.
7
Press the or button on the operator panel to select [Setting] and press
the (ENTER) button.
8
Select [Paper Setup], and then press the (ENTER) button.
9
Select the MP tray, and then press the (ENTER) button.
10
Set [Paper Size].
11
Set [Media Type].
12
Set [Media Weight].
13
Press the (ONLINE) button to return to the standby screen.
• Do not load paper in different sizes, types, or weights.
• When adding sheets of paper, remove paper loaded in the MP tray, bundle the whole batch of sheets, and align
edges of sheets to load them.
• Do not insert objects other than paper in the MP tray.
Store paper under the following conditions to maintain quality.
• Inside a cabinet or other dry and dark place
• On a flat surface
• Temperature: 20°C
• Humidity: 50% RH (relative humidity)
Do not store paper in the places as shown below:
• Directly on the floor
• Where paper is exposed to direct sunlight
• Near the inside of an exterior wall
• On an uneven surface
• Where static electricity may be generated
• Where temperature excessively rises high and temperature rapidly changes
• Near this machine, an air conditioner, a heater, or duct
• Do not unwrap paper until just before you use.
• Do not leave paper unwrapped for a long period. Doing so may result in printing problems.
• Depending on the print media, environment, storage conditions the print quality may deteriorate or printout may get
curled.
Paper storage
To Next Page
Loading...
Need help?
General
