44205401TH Rev.1
134 /
Oki Data CONFIDENTIAL
7. Troubleshooting and repair procedure
Panel display
(The mark indicates no
message in the upper row.)
ON
LINE
lamp
Inspection
lamp
Details
Remedial
measure
%COLOR% Toner
Sensor Error
Varies On Toner sensor warning:
Indicates the printer has a toner
sensor problem. Be sure the
image drum cartridges and toner
cartridges are properly installed.
Toner sensor error:
Indicates a toner sensor failure
occurred, toner cartridge lever
turning was omitted or an image
drum is not properly installed.
Be sure the toner cartridges and
image drums are properly installed.
Contact an appropriate customer
service center when this error
persists.
Error Postscript
Blink Varies Interpreter detects an error due to the
following reason. Receive data after
this is ignored until the job completion.
When the job is completely received,
this is automatically cleared.
- The job has a gr
ammatical error.
- The page is complicated, and VM
was used up.
%COLOR% Image
Drum Near Life
Varies On
(Off)
The life of the drum (warning).
Displayed in a combination of other
message in the first line. The printer
stops at the point when it reaches the
drum life (Shifts to error, OFF-LINE.)
Moreover, when set as Admin Setup
"System Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
%COLOR%
Yellow
Magenta
Cyan
Black
−
Fuser Unit Near Life
Varies On
(Off)
Notifies the fuser unit is near its life.
Moreover, when set as Admin Setup
"System Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
−
Panel display
(The mark indicates no
message in the upper row.)
ON
LINE
lamp
Inspection
lamp
Details
Remedial
measure
Belt Unit Near Life
Varies On
(Off)
Notifies the belt unit is near its life.
This is a warning; thus, printing will
not stop.
Moreover, when set as Admin Setup
"System Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
−
Change Fuser Unit
Varies On Notifies the life of the fuser unit
(warning). Displayed in a combination
of other message in the first line.
Warning only (No Life error).
This appears when the cover was
opened and closed just after the
fuser life error occurred.
Replace the
fuser with the
new fuser.
Change Belt Unit
Varies On Notifies the transfer belt is end of its
life (Warning).
This status message is displayed
when opening/closing a cover or
turning power on again after the
transfer belt life error or belt waste
toner full error occurs.
Replace the
belt unit with
the new belt
unit.
%COLOR% Toner
Empty
Varies On Notifies toner is empty.
This status message (warning) is
displayed when opening/closing a
cover or turning power on again after
the toner empty error occurs.
%COLOR%
Yellow
Magenta
Cyan
Black
Replace
the toner
cartridge with
the new toner
cartridge.
%COLOR% Toner Not
Installed
Varies On Indicates that the toner cartridge is
not installed. This status is warning
only.
%COLOR%
Yellow
Magenta
Cyan
Black
Install
the toner
cartridge. Be
careful that the
toner cartridge
supplied with
the product
cannot be
used if the
toner cartridge
of other supply
is used.
To Next Page
Loading...
Need help?
General
