- 26 -
Preparing Your Printer
1
1. Setup
7 Close the access cover (1).
1
8 Plug the AC cord and Ethernet or USB
cable into your printer, and then turn on
the power switch.
9 Press the scroll button or on the
operator panel.
10 Press the scroll button to select
[Conguration] and press the
<ENTER> button.
11 Press the scroll button several times
to select [System] and press the
<ENTER> button.
12 Press the scroll button several times to
select [RAM] and press the <ENTER>
button.
13 Check that the value of [RAM] has
increased.
- For memory expanded to 256 MB, it is
[512 MB]; for memory expanded to 512
MB, it is [768 MB].
Note
● If the value of [RAM] has not increased, turn off
your printer and unplug the AC cord and Ethernet or
USB cable, and then reinstall the additional RAM.
14 Press the <ON LINE> button.
To Next Page
Loading...
Need help?
General
