- 27 -
Preparing Your Printer
1
1. Setup
Installing the 16-GB SD Memory
Card Kit
For storing print data or a secure printing, install
the SD memory card kit.
SD memory socket
SD memory card
Memo
● The SD memory socket is attached to the SD memory
card.
Note
● Use only genuine Oki Data products. The performance
cannot be guaranteed when using other products.
● The static electricity may cause damage to the parts.
Discharge the static electricity in your body by touching
grounded metallic parts, etc. before work.
● You can not use the SD memory card with the protection
switch for accidental overwriting locked. Make sure to
release the lock.
1 Turn off your printer, and then unplug
the AC cord and Ethernet or USB cable.
Reference
● “Turning Off the Power” P.21
2 Open the access cover (1).
1
3 Remove the metal plate (2) by sliding it
upward.
(1) Put your nger in the recess of the
metal plate (2), and slide it upward.
2
(2) Pinch the lower part of the metal
plate (2), and pull it forward.
2
4 Make sure the LED (3) indicated by the
arrow turns off. If it is lit, wait until it
turns off.
3
To Next Page
Loading...
Need help?
General
