Oki Data CONFIDENTIAL
44043511TH Rev.2
246 /
Display on the operator panel Meaning Measures
Network Initializing The network configuration is being
initialized.
Wait for a while.
Network Configuration Writing The network configuration is being
saved.
Wait for a while.
Density Adjusting The printer is adjusting density. Wait for a while.
Waste Toner Transfer Error An error has occurred during transfer
of waste toner.
Open the top cover and reinstall the
drum basket.
Waste Toner Near Full The life of a waste toner box is about
to end.
Prepare a new waste toner box but
not unnecessary to replace it now.
Check Waste Toner Box Since a waster toner box is not
installed correctly, it must be
reinstalled.
Reinstall a waste toner box.
Waste Toner Full A waste toner box is full, so it must
be replaced with a new one.
Replace it with a new waste toner
box.
Centro I/F Error A parallel I/F error has occurred. Press the ONLINE button.
Staple Jam A staple jam has occurred in the
stapler unit of the finisher.
Remove every jammed staple.
Check Punch Chip Box The punch dust box is full or not
installed.
Empty the punch dust box or install it
correctly depending on the cause.
File Accessing The printer is accessing a file in an
internal hard disk.
Wait for a while.
File System Operation failed
<nnn>
An error has occurred while the
printer was accessing a file in an
internal hard disk.
Normal printing is available. Contact
the customer support center if the
error remains.
File System is Full A hard disk (an option) or flash
memory has run out of free space.
Normal printing is available.
File System is Write Protected Data is written to either a hard
disk (an option) or a flash memory
without authorization.
Normal printing is available.
Checking File System The file system is being checked. Wait for a while.
Print File List A file list is being printed. Wait for a while.
Install Finisher The finisher is disconnected from the
inverter. It is necessary to connect
the finisher to the inverter.
Connect the finisher to the inverter.
Check Finisher
Staple Jam
A staple jam has occurred in the
stapler unit of the finisher. It is
necessary to remove every jammed
staple.
Remove every jammed staple.
Check Finisher
Paper Jam
A paper jam has occurred in or near
the finisher.
Disconnect the finisher and the
inverter and remove the jammed
paper.
Check Finisher
Paper Remain
Paper is remaining in or near the
finisher.
Disconnect the finisher and the
inverter and remove the remaining
paper.
Print Font A font list is being printed. Wait for a while.
Press ONLINE Button for
Restoration
It is necessary to press the ONLINE
button to restore.
Press the ONLINE button.
Black Toner Not Installed A black toner cartridge is not
installed in the printer, or an
unrecognized black toner cartridge is
installed.
Install a genuine black toner cartridge.
To Next Page
Loading...
Need help?
General
