Oki Data CONFIDENTIAL
44043511TH Rev.2
263 /
Function
LCD
Status Message Help Message
Indicates that message data to be updated is being
processed.
Wait a Moment
Message Data Processing
–
Indicates that message data to be updated is being
written.
Wait a Moment
Message Data Writing
–
Indicates that message data to be updated has
been written successfully.
Power Off/On
Message Data Received
OK
–
Indicates that writing of message data to be
uploaded has been failed.
%CODE% is a decimal value (one digit) and
represents the cause of failure in writing.
= 1 … FAIL: Other errors.
= 2 … DATA_ERROR: Hash check error in data
reading/writing, or abnormal FLASH
= 3 … OVERFLOW: Downloading failure due to
FLASH memory full at starting or during
writing in a language file
= 4 … MEMORYFULL: Memory reservation failure
= 5 … UNSUPPORTED_DATA: Downloading data
unsupported on the printer
Check Data
Message Data Write
Error<%CODE%>
–
Shows an instruction to route printed output to the
face-up stacker of the printer was made with the
stacker closed (with a finisher installed).
Open Stacker
Face Up Stacker
Please see HELP for details
Error Code: 580
[Context]
The face up stacker cover is
closed.
[Action]
Separate the inverter from the
printer.
Open the face up stacker.
Open the paper guide plate.
Open out the paper support.
Remove printed sheets of paper.
Close the face up stacker.
Connect the inverter to the printer.
Shows an instruction to route printed output to the
face-up stacker of the printer was made with the
stacker closed (with no finisher installed).
Open Stacker
Face Up Stacker
Please see HELP for details
Error Code: 580
[Context]
The face up stacker cover is
closed.
[Action]
Open the face up stacker.
Open the paper guide plate.
Open out the paper support.
Shows the punch chip box of the printer’s finisher is
full of punch chips or not installed.
Check Punch Chip Box
Please see HELP for details
Error Code: 472
[Context]
The punch chip box is full or not
attached.
[Action]
Dismount the finisher from the
inverter by pressing the finisher
lever.
Remove the punch chip box
from the right side of finisher.
(Attach the punch chip box if
not yet attached.)
Dispose of punch chips.
Reinstall the punch chip box.
Connect the finisher to the
inverter.
To Next Page
Loading...
