Custom page size 83
3. In the PostScript Custom
Page Size Definition
window, Choose your
[paper feed direction]
from the drop-down list.
The available choices
are:
Notice that the size ranges available swap places when you
change the paper feed direction between a portrait and a
landscape choice.
Remember that the width of the multipurpose tray is
limited to the width of an A3 sheet (297mm), so if your
paper is longer than this you will have to feed it short edge
first.
4. You can also position the page image on the paper to
avoid printing too close to the edge by choosing an
[Offset].
Offset relative to [perpendicular] direction adds to your left
margin.
Offset relative to [parallel] direction adds to your top
margin (normal feed) or bottom margin (flipped feed).
5. Click [OK] to close the PostScript Custom Page Size
Definition window.
6. Click [OK] to close the Advanced Options window.
7. In the driver’s window, choose the [Multipurpose Tray] as
the [Paper Source].
Short edge first The page is portrait (tall) format and you will feed
the top of the page into the printer.
Long edge first The page is landscape (wide) format and you will
feed the top of the page into the printer.
Short edge first
flipped
The page is portrait (tall) format and you will feed
the bottom of the page into the printer.
Long edge first
flipped
The page is landscape (wide) format and you will
feed the bottom of the page into the printer.
To Next Page
Loading...
Need help?
General
