Oki MB441MFP - Telnet

Windows Utilities
-124-
 For Windows PS Drivers
1 Launch the printer properties screen.
Reference
 "Launch the Utility" P. 123
2 Select the [Device Settings] tab.
3 Click on [Get installed options
automatically] and then click on
[Setup].
4 Click [OK].
Uninstall the Utility
1 Click on [Start], and then select
[Control Panel]>[Add or Remove
Programs].
2 Select [OKI Network Extension] and
click on [Remove].
3 Follow the instructions on the screen and
complete the uninstallation.
TELNET
You can configure each type of setting with a
Telnet command.
Note
 Telnet access to the machine settings is turned off in the
initial settings.
In order to use Telnet commands, set [Telnet] to
[Active], either on the webpage or on the machine control
panel.
 For Windows 7/Windows Vista/Windows Server 2008 R2/
Windows Server 2008, Telnet commands are inactive in
the initial settings.
In order to use Telnet commands, select [Start] >
[Control Panel] > [Programs] > [Programs and
Features] > [Turn Windows features on or off]. Set
[Telnet Client] to active in the displayed dialog box.
Memo
 For the next procedure, the following environment will be
used as an example. The details may differ depending on
the OS you are using.
-OS: Windows 7
- IP Address: 192.168.0.2
- MAC Address: 00:80:87:84:9C:9B
1 Click on [Start] and select [All
Programs]>[Accessories]>
[Command Prompt].
2 Following "(Driver Password): /Users/
Username>" enter "ping (Space)
machine IP Address".<Press the
Enter> key and check that access is
enabled.
E.g.: "C:/Users/WINDOWS > ping 192.168.0.2"
3 Following "telnet (Space)", enter the IP
address of the machine and press the
<Enter> key, in order to access the
machine through Telnet.
E.g.: "C:/Users/WINDOWS>telnet 192.168.0.2"
4 After "login:" enter "root" and press the
<Enter>.
5 If a prompt is displayed, enter your
password following "Password" and press
the <Enter> key.
Enter E.g: "password: 849C9B".
Memo
 The default "root" password is the last 6
alphanumerical digits of the machine's MAC address.
6 If a menu command is displayed, enter
the menu number you would like to
change, and press the <Enter> key.
7 Change the settings as required.
8 Save settings and log out of the
machine.