EasyManua.ls Logo

Oki MB441MFP - Page 84

Oki MB441MFP
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
List of the Device Setting Menu Items
-84-
Secure Receive Setting OFF Sets whether to use the secure receive
function.
Password (NULL) Sets password for printing received docu-
ments in memory.
Other
Settings
Redial Tries 2 times Sets the number of redial attempts.
Available range: 0 to 9 times.
Redial Interval 1 minute Sets the time between redial attempts.
Available range: 1 to 5 minutes.
Block Junk Fax Setting OFF Sets the mode of Block Junk Fax.
Registered
List
Register/Edit (No Entry)
Register/Edit addresses for Block Junk Fax.
Display condition: [
Admin Setup
]>[
Other
Settings
]>[
Block Junk Fax
]>[
Setting
] is
set to [
Mode2
].
Delete
(Nothing: con-
nect Item cell
and Factory
default cell)
Delete addresses for Block Junk Fax. Dis-
play condition: [Admin Setup]>[Other
Settings]>[Block Junk Fax]>[Setting] is
set to [Mode2].
Ring Response 1 ring Sets the number of rings required before
receiving an incoming fax.
Dialling Pause Duration 2 seconds Sets the dial pause time.
Available range: 0 to 10 seconds.
Rx Reduc. Rate Auto Sets the reception reduction rate.
Reduc. Margin 24 mm or 3.9
inch
Sets the threshold level of reception
reduction.
Available range: 0 to 100 mm
(0 to 3.9 inches).
ECM Mode ON Sets whether to use the error correction
mode.
PreFix NULL Sets the dialing prefix. Maximum 40 dig-
its.
Received Time Stamp OFF Sets whether the time stamp is printed on
incoming faxes.
Print Check Message ON Sets whether the error content is reported
when a transmission error occurs.
Fax
Setting
Service Bit OFF If set OFF, some menu items are not dis-
played on the panel.
Country Code International
or U.S.A or
Australia(Sin-
gapore)
Sets the country code.
A/R Full Print ON Sets whether to print the list of the com-
munication results automatically after
every 50 communications.
Tone For Echo (For Transmission) Disable It only shows, when ServiceBit = ON.
Tone For Echo (For Reception) Disable It only shows, when ServiceBit = ON.
H/Modem Rate(For Tx) 33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
sending a fax.
H/Modem Rate(For Rx) 33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
receiving a fax.
Attenuator
10 dB, Range :
0-15 dB
Enter Attenuator.It only shows, when Ser-
vice Bit = ON.
Item
Factory
Default
Description

Table of Contents

Related product manuals