44952001TH Rev.2
5-33
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
• IfyouwanttospecifythePUserialnumber,pleaseadda"0"(a
normal-widthzero)theninputthe11-digitnumber.(Pleasenotice
that when read out, the number will be 10 digits.)
As shown in the following image, on the menu of [PU serial
number setting], eliminate the 2-digit revision number then add a
normal-widthzerotothe10-digitnumberandinputit.
• Onthemenuof[Section2.4.1.1.4.3,Serialnumberinformation
setting] of [Section 2.4.1.1.4 CU circuit board setting function],
set the [Choose printer serial number] to [CU serial number] and
[Output mode] to [Show both].
• IfyouwanttospecifytheCUserialnumber,pleaseinputthe
12-digit number. (When read out, it will be 12 digits, too.)
Figure of Serial No. label image (labeled in UK Factory)
Add one-byte 0 to the top of 10-digit figure of Lot.NO.
Set "0AE47027880" in the setting screen.
Revision
Ser.NO. 4AEL4011702K
Lot.NO. AE47027880 A0
Made in Thailand
Configured in UK
• PUserialnumberwillbeoutputtothePrinterSerialNumber
column in the header of Status Page. For this reason, check of PU
serial number is performed by printing
Status Page.
• AfterthecongurationintheUKfactory,whenfacingOEL,the
PU serial number is taken as Lot Number and shown in the Lot
Number: column of the last line which is in the header of the
Status Page.
(1-2) Set the CU serial number
SAP serial number can be applied to the device. The SAP serial
number is displayed in the highest rung of the serial number label. It
is a 12-digit number including production place (2 digits), production
year (2 digits), sequence number (6 digits) and revision number (2
digits).
• CUserialnumberisgivenanoriginalnumberwhichiswithin12
digits in the UK factory.
• PleasenoticethatifyousettheCUserialnumber,themenu
setting in CU will be reset (back to the default setting). (For
reference, Maintenance utility operation manual)
Figure of Serial No. label image (labeled in UK Factory)
Input 12 digits for Ser. NO. Input "4AEL4011702K".
Ser.NO. 4AEL4011702K
Lot.NO. AE47027880 A0
Made in Thailand
Configured in UK
• CUserialnumberisshowninthePrinterSerialNumberColumnin
the header of Status Page. Therefore, the confirmation of the CU
serial number after the change can be done by printing the Status
Page.
• ThePUserialnumberisshownintheLotNumber:columnofthe
last line which is in the header of the MenuMap.
To Next Page
Loading...
Need help?
General
