EDITING FUNCTIONS
- 105 -
4
Set “outside erase”.
1) Press [ON].
2) Adjust the width of the border around the original
by pressing either or as required.
When you adjust it to the side, the area to be
detected as not belonging to the original is widened.
When you adjust it to the side, the area to be
detected as not belonging to the original is narrowed.
3) Press [OK].
5
Place the original on the document glass.
Press [ZOOM] and set the size of the original.
Basic Guide
• When placing the original, be sure that the Original
Cover or the RADF is fully raised. If not, this function
may not properly be able to detect the border between
the original and areas not belonging to it.
• Do not directly look at the document glass during
copying since an intense light may leak.
Do not place any heavy objects (8kg (18lb.) or over)
on the document glass and do not press on it with
force.
Breaking the glass could injure you.
6
Select other copy modes as required, and
then press the [START] button on the
control panel.
To Next Page
Loading...
Need help?
General
