Oki mc760x - Setting IEEE 802.1 X Authentication

SETTING ITEMS (ADMIN)
- 305 -
2
1
3
4
5
6
7
Memo
• For instructions on how to install certificates, refer to the
TopAccess Guide “Chapter 8: [Administration] Tab
Page”.
• For instructions on how to display the WIRED 802.1X
SETTINGS screen, see the following page:
 P.250 "Accessing the Admin Menu"
Setting IEEE 802.1X authentication
1
On the WIRED 802.1X SETTINGS screen,
specify the following items as required and
press [NEXT].
2
Proceed with the operation that you
require.
If you selected [EAP-MSCHAPv2], [EAP-MD5] or [EAP-
TLS], proceed to step 5.
3
Select the inner authentication method and
press [Next].
Selecting inner authentication method is necessary only
when you selected [PEAP] or [EAP-TTLS] in step 3.
Item name Description
802.1X • ENABLE — Press this button
to use IEEE 802.1X
authentication.
• DISABLE — Press this button
to disable IEEE 802.1X
authentication.
Memo
• When changing
IEEE802.1X authentication
from [ENABLE] to
[DISABLE], press [Next],
and on the “Confirm the
following settings” screen
that appears, press [APPLY
NOW] to complete the
setting.
CHECK
SETTINGS
Press this button to confirm the
options currently selected.
Note
• [CHECK SETTINGS] is
available when you selected
[ENABLE] for 802.1X.
FACTORY
DEFAULT
Press this button to reset the
IEEE802.1X settings back to the
factory defaults.
When you selected [PEAP]:
When you selected [EAP-TTLS]: