3.2
3.2.1
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Disassembly and Reassembly
.Procedures
Upper cover
Turn OFF the AC POWER switch, and remove AC cable
@
from the outlet, and then
remove interface cable
@
,
remove paper.
Remove acoustic cover and paper separator (if installed).
Remove tractor feed unit
@
by depressing lock lever
@
and tilting backward (if it is
installed).
Remove roll paper with paper shaft
@
by lifting upward. Remove side frame
@
by
tilting forward (if it is installed).
Remove access cover
@
by lifting rear, edge.
Pull platen knob
@
out
Remove two screws’@.
Remove upper cover
@
by lifting up front and pushing it backward.
For reassembly, reverse the disassembly procedure.
3-2