Oki Microline 182 User Manual

3.2.8
(1)
(2)
(3)
(4)
(5)
6)
(7)
Space motor assembly
Remove the upper cover (see 3.2.1).
Remove the print head (see 3.2.6).
Remove the ribbon feed gear assembly (see 3.2.7).
Remove connector 0, and observe concave surface.
Remove three screws 0.
Remove space motor assembly 0.
For reassembly, reverse the disassembly procedure.
1.
2.
3.
4.
Notes:
Do not touch the space motor assembly @ terminal (contact) @ direcfly with hand
and make sure that if is clean.
When installing space motor assembly 0, put the @ side of the assembly close to
carriage frame @, and align the @ side of the assembly with the corresponding side
of the carriage frame.
When installing slider 0, put the @ and @parts of the slider close to space motor
assembly 0.
Afterinstalling space motorassembly 0, checkandadjusf fhegap between fheplafen
and print head (see section 5).
3-16

Oki Microline 182 Specifications

General

Brand	Oki
Model	Microline 182
Category	Printer
Language	English