Oki ML620 - Page 57

ML620/ML621 User’s Guide 57
MENU SETTINGS TABLE
Group Item Function Settings (defaults are set in bold italic)
Cut Sheet
Front Feed
(cont.)
LF Revise Adjust the line feed in cut sheet
mode.
–14 ~ –1, 0, +1 ~ +14
Centering Position Used to limit printhead travel
when printing narrow columns.
Select Mode 1 for ML620. Select
Mode 1 or Mode 2 for the ML621.
Default, Mode1, Mode2
Set-Up Graphics Set the printing direction when a
line has double-height print data.
Specify uni-directional graphics
for better registration, but slower
printing.
Bi-directional, Uni-directional
7 or 8 Bit Graphics
7
(only displayed for ML
Emulation)
Change this setting to 8 if your
system uses 8-bit graphics.
8, 7
Receive Buffer Size
2
Selects the amount of memory
devoted to holding received data.
Choosing “1 Line” will tie up your
computer while printing, but if you
abort the print job, the printer will
stop much sooner.
1 Line, 32K, 64K, 128K
Paper End Detection Set whether to detect paper end
or not. To override the sensor and
print closer to the bottom of the
page, set to OFF.
On, Off