Paper handling > 18
Loading continuous forms
Setting up continuous forms
To avoid paper feeding problems, carry out the following:
1. Check your printer is on a surface approximately 30
inches (75 cm) above the floor.
2. Position the continuous forms supply directly below the
printer, no more than 1.18 inches (3 cm) left or right of
the printer paper path.
3. Ensure the rear of the printer is close to and parallel with
the edge of the surface and at least 24 inches (60 cm)
from any wall.
Feeding continuous forms
1. Ensure that the printer is turned ON.
Note
If there is a cut sheet in the printer, eject it as
described in “Ejecting cut sheet paper” on page 17.
>=60 cm
75 cm
<=3 cm
To Next Page
Loading...
