Troubleshooting > 46
7. When the paper jams are cleared, close the Rear Cover by
gently swinging it downwards to the horizontal and then
pushing it inwards until it locks into position.
8. Set the Power Switch to ON.
Responding to alarm conditions
Use the following table for guidance on how to respond to
indicated alarm conditions.
Indicator
Alarm meanings and actions
SEL ALARM
OFF ON Paper has run out. Add paper and press the
SEL button.
OFF Flashin
g
The Paper Type lever is wrongly set for the
type of paper in use. Press the SEL button
and set the Paper Type lever to the correct
position.
OFF Flashin
g
Problem with cut sheet feeding. Remove the
cut sheet.
Flashin
g
ON Print data is received but printing does not
start because no paper is being fed. Insert
paper.
Flashin
g
Flashin
g
Printing cannot be resumed at this stage.
Turn the power OFF, verify that the carriage
moves properly, then turn the power ON
again.
If the problem is still there after you turn
the power ON again, contact your dealer.
To Next Page
Loading...
