Paper handling > 22
9. Close the Rear Cover by gently swinging it downwards to
the horizontal and then pushing it inwards until it locks
into position.
10.Press the FF/LOAD button. The continuous forms will be
taken into the printer and positioned at the first line print
position and the SEL indicator will illuminate.
Tearing off continuous forms
1. With the SEL indicator illuminated, press the TEAR button
to eject the continuous forms onto the Paper Tray.
2. Carefully tear off the forms along the tear-off perforations
in the direction shown. Using excessive force may result
in tearing at a position other than the tear-off
perforations.
3. Press the TEAR button, FF/LOAD button or LF button to
reposition the continuous forms in the printer back to the
first line print position.
Aligning the tear-off perforations
If the tear-off perforations are not aligned with the paper
cutter on the Top Cover, align them as follows:
1. With the SEL indicator illuminated, press and hold the
TEAR button to move the tear-off perforations to the
paper cutter on the Top Cover.
To Next Page
Loading...
