Paper handling > 21
7. Open the left and right Pin Tractor covers (1) and feed the
continuous forms in the direction of the arrows, locating
the sprocket holes (2) in the forms onto the sprocket pins.
Ensure that the forms are properly aligned on the
sprocket pins (3), then close the covers.
8. Adjust the right Pin Tractor (1) to accommodate the width
of the continuous forms, taking care that the forms are
held neither too loosely nor too tightly between the Pin
Tractors. Press the locking lever (2) down to lock the right
Pin Tractor in the desired position.
1
2
3
1
2
To Next Page
Loading...
