Getting started > 7
4. Power Switch: to turn the printer power ON/OFF.
5. Platen Knob: turn to move or eject the paper.
6. Paper Tray: to hold cut sheet paper for use by the printer
(one sheet at a time).
7. Paper Guide: can be adjusted as required to locate the
left edge of cut sheet paper.
8. Paper Type Lever: set according to the type of paper used
– cut sheet or continuous forms.
9. Paper Thickness Lever: set according to the thickness of
the paper. There is also a setting to facilitate ribbon
replacement.
10.Ribbon Cartridge: holds the printer ribbon.
1
2
3
4
5
6
7
8
9
1
To Next Page
Loading...
