Oldham MX 32 - Chapter 2 │General Introduction; Purpose of the MX 32 Controller

2 – General introduction
3
Chapter 2 │General Introduction
Purpose of the MX 32 controller
This controller is intended for the continuous measurement and control of the
gases present in the atmosphere.
MX 32
8 relay output modules and 4
4-20mA output modules
Figure 1: MX 32 and examples of the modules
The system primarily comprises:
■ a MX 32 (1 or 2 lines),
■ different modules (analog or digital detectors, logic inputs, analog inputs,
relay outputs, and analog outputs).
The MX 32 instantly handles the measurements of detectors and input
modules. As soon as the measurements reach the configured thresholds, the
internal buzzer and the LED indicators go off. At the same time, the
corresponding relays are activated to drive the additional actions programmed
by the user.
The MX 32 controller is programmed by using the COM 32 configuration
software.
Figure 2 presents a configuration example.