a. Move the right side
of
the second
seat forward for access
to
the
third
seat area.
b. Release (lift) the third seat back
remote
control lock handle located
on the right wheelhouse trim and
allow seat back
to
lower
to
load
floor
position.
c. Lift up seat back
filler panel;
then,
push down on hinge area
of
panel
while
lowering filler panel
to
lock
panel
in
load floor position.
To
raise
the
third seat
to
sitting position,
proceed as
follows:
1. Move the right side of the second seat
forward for access
to
the
third
seat area.
2.
Lift
third seat back hinged filler panel
rearward
onto
seat back, then, grasp
seat back handle and
lift seat back
upward
until it locks
in
the
full
"up"
position.
CONCEALED
LUGGAGE
COMPARTMENT
Both
two
and three seat models have a
covered storage compartment. An
optional ,
lock
is
available which enables the cover
to
be locked
to
provide protection for the
contents. The
lock
is
operated by
the
round
-
end
key. The cover
to
the
compartment
on
the
3-seat model may be
held
in
the
raised position by a
support
bar
which
is
located
at
the rear
of
the
compartment
. Swing
the
bar up and place
47
To Next Page
Loading...
