UNIX> 71
99 : Exit setup
Please select (1- 99)?
5. Type 1 and press the [Enter] key. Perform the following
settings:
Please select (1- 99)? 1
No. Message Value
1 : TCP/ IP protocol : ENABLE
2 : IP address : 192.168.20.127
3 : Subnet Mask : 255.255.255.0
4 : Gateway address : 192.168.20.1
5 : RARP protocol : DISABLE
6 : DHCP/ BOOTP protocol: DISABLE
7 : Auto IP Address : DISABLE
8 : DNS Server (Pri.) : 0.0.0.0
9 : DNS Server (Sec.) : 0.0.0.0
10 : root password : “******“
11 : Auto Discovery Setup
99 : Back to prior menu
Please select (1- 99)?
6. Logout from the network interface card. Turn the printer
off for about 15 seconds and on again to validate the
settings.
To Next Page
Loading...
Need help?
General