49
CKX53
Proper selection of the power cord
If no power cord is provided, please select the proper power cord for the product by referring to “Specifications” and
“Certified Cord” below:
Caution : In case you use a non-approved power cord for Olympus products, Olympus can no longer warrant the
electrical safety of the product.
A power cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage marked with an agency
marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of the agencies listed in Table
1. In case you are unable to buy locally the power cord which is approved by one of the agencies mentioned in Table 1,
please use replacements approved by any other equivalent and authorized agencies in your country.
Country Agency
Certification mark
Country Agency Certification mark
Argentina
IRAM Italy IMQ
Australia SAA Japan JET, JQA,
Austria ÖVE Netherlands KEMA
Belgium CEBEC Norway NEMKO
Canada CSA Spain AEE
Denmark DEMKO Sweden SEMKO
Finland FEI Switzerland SEV
France UTE
United
Kingdom
ASTA
BSI
Germany VDE U.S.A. UL
Ireland NSAI
Table 1 Certified cord
Specifications
Voltage rating
Current rating
Temperature rating
Length
Fittings configuration
125 VAC (for 100-120 VAC area) or, 250 VAC (for 220-240 VAC area)
6 A minimum
60 ˚C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC
configuration appliance coupling.
To Next Page
Loading...
