Olympus CKX53 - Operating Procedures of CKX3-SLPIC (Option); Selecting Procedures of the Specimen Holder (Option)

23
CKX53
4-9 Operating procedures of CKX3-SLPIC (option)
Combining the IC ring slit CKX3-SLPIC with the objective (PLCN10X or
CACHN10XIPC) enables to perform the IC observation.
The IC observation is featured that the contrast of the observed image is
reversed depending on the focal point of the specimen.
Slide the pre-centered phase contrast slider CKX3-SLP
c
and engage
the IC ring slit CKX3-SLPIC
d
attached to the slider in the light path.
For procedures to attach the IC ring slit CKX3-SLPIC
d
to the
pre-centered phase contrast slider CKX3-SLP
c
, see page 40.
Rotate the revolving nosepiece to engage the objective (PLCN10X
or CACHN10XIPC) in the light path.
1
TIP
2
c
d
4-10 Selecting procedures of the specimen holder (option)
The container size differs depending on each container maker. For the size of the container holding portion of
the specimen holder, see page 30.
TIP
Container type
Specimen holder
a b c d e f
Petri dish 35 mm ¦ - - - ¦ ¦
Petri dish 60 mm ¦ ¦ - - - ¦
Slide glass
-
¦ - - - ¦
Slide chamber - ¦ - - - ¦
Blood cell test plate - - - ¦ - ¦
Terasaki plate - - ¦ - - ¦
Cell culture flask 25 cm
2
- - - - - ¦
Various specimen holders are prepared as options for holding different types of containers.
a
Petri dish holder (IX-HOP)
b
Slide glass holder (IX-HOS)
c
Terasaki holder (IX-HOT)
d
Blood cell test plate
holder (IX2-BCTP)
e
Multi 35 petri dish holder
(CKX3-HO35DM)
f
Universal holder
(CKX3-HOUN)
The following table shows the specimen holders corresponding to various containers.