Do
not
push
the
button
with an
edged
object.
CD
EVIS
100/200 System
is
automatically set to "AUTO". Check the
CINE.
TV
and the AUTO
indicators being lit.
@ For
OES
System, press the AUTO/MANUAL Brightness Selector.
At
each pressing, a peep
sounds and AUTO/MANUAL
is
switched alternately. Check the
CINE.
TV
indicator at AUTO
and the Illumination Light at MANUAL being illuminated and then
is
set to MANUAL.
* If
the
CINE
·TV
switch
is pressed
without
connecting
to
TV camera,
AUTO/MANUAL
Brightness
Selector
can
function
and
the
illumination
light
output
may
be
minimized.
Q)
Press the Brightness Control switch
,,,,,
Ii",).
At
each pressing, a peep sounds and the LED
light goes
up
(downl one step
with
increased (decreasedl illumination light output.
Keep the switch depressed: the peep sounds continuously, and the LED light goes up
(down) sequentially
with
increasing (decreasing) light output until "MAX" ("MIN")
is
reached.
* Once
"MAX"
("MIN") has been reached, pressing
the
switch
) dose
not
cause
any
further
change.
*
If
the
endoscope
is
disconnected,
the
LED
indicator
light
will
still
change
as
described
above,
but
the
actual
output
brightness
remains
at a
low
level
until
the
endoscope
is
connected.
* The
switch
should
not
be pressed
with
a
pointed
or
hard
object
since
this
will
damage
the
rubber
covering.
CD
Dip the fiberscope distal end
in
clean water.
(2)
Press the air Regulator switch: A peep sounds, and the LED indicators turn
on
sequentially.
Air
flow
rate (identifiable by bubble amounts when the air/water valve
on
the fiberscope
is
occluded, or by pump noise) varies
with
each setting.
* The air
pump
does
not
operate
when
the
endoscope
is disconnected.
Q)
Set the pressure level to "HIGH" by pressing the switch. Make sure the water
is
emitted
through the distal end nozzle.
D
InsJlecti<1O
Inspection
of
turning
on
and
off
alternatively
lAdjustment
of
output
intensity]
Ell
:;e
Ll.J
f0-
Ul
>-
Ul
u
0:
o
u
Ul
o
o
Z
Ll.J
LL
o
Z
o
B
Ll.J
CL
Ul
Z
[Adjustment
of
air
feeding
pressure)
To Next Page
Loading...