14
DP73
1. To clean the lenses and other glass components, simply blow away dirt using a commercially available
blower and wipe gently using a piece of cleaning paper (or clean gauze).
If a lens is stained with fingerprints or oil smudges, wipe it with gauze slightly moistened with commercially
available absolute alcohol.
Since the absolute alcohol is highly flammable, it must be handled carefully. To prevent fire ignition, be
sure to keep it away from open flames or potential sources of electric sparks – for example, electrical
equipment that is being switched on or off.
Also remember to always use these chemicals only in a well-ventilated room.
2. Parts other than the glass components should be cleaned by wiping with a clean cloth. Do not use organic
solvents to remove major stains. Use a soft cloth slightly moistened with a neutral detergent solution.
3. Do not disassemble any part of the camera as this could result in malfunction or reduced performance.
4. When the camera is removed from microscope for storage, be sure to put the C-mount cap included in the
camera, which is necessary to protect the IR cut filter provided inside.
5. When the camera is stored, be sure to keep the C-mount portion downward, since it tends to roll over.
6. When disposing of this product, check your local regulations and rules and be sure to observe them strictly.
CAUTION
4
Maintenance and Storage
To Next Page
Loading...
