80
EPOCH 4PLUS
2. Press [F4] to abort.
To insert a new file, follow these steps:
1. Pressing [F2] prompts you to enter one of the following:
a. Press [F1] to insert a new file. A blank file is then be inserted before the
highlighted selected file.
b. Press [F2] to abort.
To delete the file, follow these steps:
1. Pressing [F3] prompts you to enter one of the following:
a. Press [F1] to delete the file. The file is deleted and the remaining files move up
one location.
b. Press [F2] to abort.
To swap the file location, follow these steps:
1. Press
[F4] and use the up and down arrow keys to select the new location for the file.
2. Press [F1] to swap desired files. The two files selected exchange places in the file
directory.
3. Press [F2] to abort.
To exit the edit function, follow these steps:
1. Press [F5] to exit the edit function. You will still be in the Memory screen.
2. Press [F5] again to return to the live screen.
Editing the File Contents Portion of the Memory Screen
When thickness readings and waveforms are saved in the datalogger, they are saved to an
individual file. The contents of these files is displayed in the File Contents portion of the
Memory Screen.
To edit individual ID codes in these files, follow these steps:
1. Use the slewing keys to move the highlight bar over the desired file in the File
Directory (lower portion of the Memory screen).
2. Press [F1] to enter the File Contents screen (upper portion of the Memory screen).
3. Use the slewing keys to review the file contents. The current ID code (either a
waveform or a thickness reading) is continuously displayed and updated at the top of
the screen as you scroll through the file.
To Next Page
Loading...
