Managing the Datalogger and Data Communication Features
Part # 910-250C
81
4. Press [EDIT] when the desired ID code is displayed.
Figure 43 Editing the File Contents
To clear the ID, follow these steps:
1. Pressing [F1] prompts you to enter one of the following:
a. Press [F1] to clear the data from the ID code (thickness readings or waveforms).
This action leaves the ID name in place and lets you save other data to the same ID.
You can then opt to begin saving new data to these same ID codes.
b. Press [F2] to abort.
To delete the ID, follow these steps:
1. Press [F3].
2. The gage prompts you to enter one of the following:
a. Press [F1] to delete the ID name and data saved in that ID location. The file will
be deleted and the remaining files will move up one location.
b. Press [F2] to abort.
To Next Page
Loading...
