Omega C9000A SERIES User Manual

19
Ensure that the jumper behind
the lower front bezel is in the
Parameter Setting Position
(refer to Section 3.13). Note
Functions .1, .2, .3 are not
protected by the Parameter
Lock Jumper.
To convert the main display
from a temperature read-out
to the Function/Option Mode:
To change from Function .0 to
Function .16 (for example)
†
:
To change flashing Function
digit to Option digit:
To change from Option 0 to
Option 2 (for example)
††
:
To go to another Function:
When finished selecting the
Functions and Options (exiting
Program Mode), the
process temperature is
displayed. Control begins with
the new instructions now
entered into memory.
3.5.1.1 Example of Programming Functions. 0, .1,.2,.3,-.23
STEP ACTION DISPLAY
1
2
3
4
5
6
7
The following steps apply only to Functions .0,-.23. Section 3.6
covers more examples.
Press P
Option 0
Function .0
(flashing)
Press and Hold
until you see 0.16
Function (flashing)
Press ★
Option (flashing)
Press 2 times
Option (flashing)
Press ★ and
repeat steps 3-5 as
necessary
Press P
†
If using button, the Function number changes in the following sequence:
":0, .1, .2,.... .25” and back to “.0”. If using button, and the display shows
“.0" in Function place, the display changes to “.13” and then “.12, .11, ..., .0".
††
If using button, the Option number goes as high as 100. If using button,
the Option number goes down to 0.
0.
0
0.
1 6
0.
1 6
2.
1 6
T E M P

Omega C9000A SERIES Specifications

General

Brand	Omega
Model	C9000A SERIES
Category	Temperature Controller
Language	English