80
APPENDIX A
FUNCTION QUICK REFERENCE GUIDE
STANDARD FUNCTIONS (.0 -.25)
OPERATOR ADJUSTMENTS
.0 Operating Modes (Autotune/Auto-manual)
.1 Manual Reset
.2 Setpoint 2 Adjust
.3 Setpoint 1 Lock
TUNING
.4 Cycle Time/On-off (Output 1)
.5 Proportional Band/Deadband (Output 1)
.6 Derivative Time/Rate (Output 1)
.7 Derivative Approach Control (Output 1)
.8 Integral Time (Output 1 )
.9 Sensor Offset (Calibration)
.10 Cycle Time/On-off (Output 2)
.11 Proportional Band/Deadband (Output 2)
.12 Loop Break Alarm Time
SPECIAL SETUP FUNCTIONS
.13 Activate Advanced Functions .26 -.50
.14 (Not Used)
.15 Resetting Functions .0 - .24 to Default Settings
INITIAL CONFIGURATION
.16 Input Sensor Select and Range Table
.17 Negative Temperatures
.18 Display Resolution (1 or 0.1 Degree)
.19 Setpoint 2 Operation Selection
.20 Sensor Break Protection (Output 1)
.21 Sensor Break Protection (Output 2)
.22 °C/°F Selection
.23 Software Version Number
.24 Upper Setpoint Limit (Span)
.25 (Not Used)
To Next Page
Loading...
Need help?
General
