Omega C9000A SERIES User Manual

21
3.5.1.3 Example of Programming Functions .24 and
Special Case of Function .2
To change from Function .19
to Function .2:
To change to Option Mode:
To change from Option
number; can go down to
-128° can go up to +127°,
since you selected option 7 in
Function .19. See the chart in
Function .2 to see the range
allowed. (For example, set to
100°).
To exit program mode (and
lock in parameters just set
up). Process temperature is
displayed.
Ensure that the jumper behind
the lower front bezel is in the
Parameter Setting position
(the jumper should be on the
two right-most pins). Refer to
Section 3.13 if necessary.
To convert the main display
from a temperature read-out
to the Function/Option Mode:
To change from Function .0 to
Function .24:
STEP ACTION DISPLAY
7
8
9
10
1
2
3
Repeatedly
Press
until you see 0.2
Function (flashing)
Press ★
Option (flashing)
Press to
increase value
Press P
Press P
Option
Function
(flashing)
Press 24
times
(flashing)
0.
2
0.
2
1 0 0.
2
T E M P
The following steps apply to Function .24 and Function .2 when
using SP2 as a full scale alarm or non-tracking second setpoint
(Function .19, Option 4 or 5).
- -
2 4
0.
0

Omega C9000A SERIES Specifications

General

Brand	Omega
Model	C9000A SERIES
Category	Temperature Controller
Language	English