Omega C9000A SERIES - Default Chapter; Table of Contents

i
TABLE OF CONTENTS
CN9000A SERIES
MINIATURE AUTOTUNE TEMPERATURE
CONTROLLER
SECTION
SECTION 1 INTRODUCTION..............................
1.1 General Description......................................
1.2 Available Models..........................................
SECTION 2 INSTALLATION...............................
2.1 Unpacking.....................................................
2.2 Cautions and Mounting Instructions.............
2.3 Wiring...........................................................
2.4 Typical Wiring Diagrams...............................
SECTION 3 OPERATION......................................
3.1 General Considerations................................
3.2 Controls and Indicators................................
3.3 Default (Pre-Set) Settings............................
3.4 Getting Started.............................................
3.4.1 Selecting Sensor and Adjusting Setpoint.....
3.4.2 Changing the Allowable Setpoint Default
Range (Function .24).................................
3.5 Parameter Adjustments (Standard
Functions)...................................................
3.5.1 Keying in Standard Functions......................
3.5.1.1 Example of Programming Functions
.0, .1, .2, .3- .23..........................................
3.5.1.2 Example of Programming Functions
.19 & .2 (SP2)...........................................
3.5.1.3 Example of Programming Functions
.24 and Special Case of Function .2.........
3.5.1.4 Details of Standard Function .0- .25............
Table 3-4, Standard Functions.0- .25........
3.6 Examples of Parameter Adjustments...........
3.6.1 Changing SP1 Proportioning Time
(Function.4)...............................................
PAGE
1
1
2
5
5
5
7
9
11
11
11
14
14
14
16
18
18
19
20
21
22
23
34
34