Omega C9000A SERIES User Manual

83
Change setpoint temperature.
Hold ★ button while pressing
"up arrow" ( ) to increase
setpoint, or alternately "down
arrow" ( ) to decrease (Note
that the digits will change
while arrows are held, slowly
at first, then more quickly).
For example, the setpoint is
set for 147°
Enter setpoint in memory and
display process temperature,
e.g., 25°C.
Change controller parameters
by accessing Functions. For
example, Function .0
(flashing) and Option 0 are
displayed.
To change Option 0 to Option
1 (for autotuning). Enable
change of option.
Increase Option 0 to Option 1
to enable autotuning.
Start autotuning. Display will
alternately flash "AT" and the
process temp until Autotuning
is finished. Unit will then read
actual process temperature.
APPENDIX B (cont’d)
QUICK STARTUP
STEP ACTION DISPLAY
5
6
7
8
9
10
Press ★, hold
Press ,
Press ★
Release or
Press P
Flashing
Press ★
Flashing
Press once
Press P
1 4 7
2 5
0.
0
0.
0
1.
0
A T
2 6

Omega C9000A SERIES Specifications

General

Brand	Omega
Model	C9000A SERIES
Category	Temperature Controller
Language	English