26
Configuration Using Display (continued) Step Four
STEP 3 - SETTING THE HEIGHT (SENSOR HEIGHT)
1. In TOP-LEVEL MENU mode, select TANK.
2. Select HEIGHT.
3. Using the UP and DOWN buttons, set the HEIGHT of
the tank (transducer face to the bottom of the tank).
4. To enter the value, press and hold OK for 3 seconds
and release. SAVED will display.
5. Select EXIT to return to TOP-LEVEL MENU.
Note: The HEIGHT setting also determines the 4 mA current location. To reverse the current output with
20mA at the bottom of the tank, use the REV MA function.
Note: To speed up the scrolling of the values on the display, hold down the OK button while holding down the
UP or DOWN buttons.
To Next Page
Loading...
