9
Getting Started Section Two
SETUP OVERVIEW
Below highlights the initial steps in setting up your sensor for operation.
1. Check Part Number (Section Two)
a. Confirm that the sensor’s part number matches the ordered part number and all components
are provided with the model delivered.
2. Measurements, Installation & Software (Section Two)
a. Understand the location placement of the sensor relative to Measurement Range including
Sensor Height and Fill-Height settings.
b. Download the LVCN414-SW software from omega.com/ftp.
3. Configure Sensor with LVCN414-SW software (Section Three)
a. Section 3 contains information on using the LVCN414-SW software configuration software.
4. Configure Sensor with Push Button (Section Four)
a. Section 4 contains information on using the Push Button Display to configure the sensor.
5. Install the sensor (Section Five)
a. Section 5 contains information about the sensor location placement and its mechanical
installation.
6. Wire the sensor (Section Six)
a. Section 6 contains information about the sensor’s electrical wiring and power requirements.
Note: When configuring LVU700 series, choose either the LVCN414-SW software or Push Button method.
Either method will accomplish the goal of sensor configuration. Changes to the configuration can be made
using the alternative method. When beginning with one method, it is recommended to complete the
configuration before using the other method to make any adjustments.
To Next Page
Loading...
